Will this bumper require modification to fit my lower valance?

This bumper uses factory mounting points and retains OEM valance geometry. Verify your lower valance clips align with the mounting tabs before final assembly. Minor fitment may require small adjustments depending on other body modifications.

Can I drill this for aftermarket fog light cutouts?

Yes. FRP is easily drilled and shaped. Measure your desired fog light placement against your bumper, mark your centers, and use a step drill or hole saw. Sand the cut edges smooth and seal with epoxy or filler before paint to prevent moisture intrusion.

What prep is required before painting?

Sand the entire surface with medium-grit sandpaper to remove the glossy gelcoat and ensure paint adhesion. Fill any voids or imperfections with polyester filler, then sand smooth. Clean thoroughly and apply your chosen primer and topcoat per manufacturer instructions.