Do I need to cut or drill into the bumper to install these?

Factory mounting points are built into the bumper — no cutting or drilling required. Check your specific bumper condition before installation to confirm fitment at the factory locations.

Will the switch wire through the dashboard easily, or do I need to run it under the car?

The switch harness runs through the engine bay and cabin. Most installs route it along existing wire channels behind the dashboard. Keep slack to avoid pinching, especially near the steering column.

Can I return these if the bulb orientation or connector doesn't match my wiring?

Check connector type against your factory harness before committing to installation. Bulb orientation is standard H11, but wiring adapters may be needed depending on your existing electrical setup. Confirm compatibility before final assembly.